Home		Prev Next
Contents RapidDriver Explorer Introduction The User Interface (Overview) Device Description Test Devices Driver Description New RapidDriver Project Step 1: Select Device Step 2: Project Description Step 3: ISA Resources Step 4: Driver Installation Generic RapidDriver Project Port I/O Memory-mapped I/O PCI Devices Working With ISA/PC-104 Devices New ISA/PC-104 Project Hardware Resources for ISA/PC-104 Input/Output (I/O) Port Ranges Memory Address Ranges Interrupt Request (IRQ) Line Direct Memory Access (DMA) Channel Test ISA/PC-104 Device Working With PCI Devices New PCI Driver Project Test PCI Device PCI Header Configuration Space Base Address Registers (BARs) Interruptions Settings for bus-master DMA Working with Parallel Port Devices New Parallel Port Project Test Parallel Port Device Parallel Port Settings LPT Pins Ports And Bits Interrupts Working With USB Devices New USB Project Test USB Device Descriptors and Configuration Vendor/Class Requests Pipe Operations Feature Requests		Test PCI Device Go to RapidDriver Main Page Attention! You should install your device before you can test it. You can do it through the main menu (Actions | Install Device Using RapidDrv.sys) or by clicking on the corresponding toolbar button. With RapidDriver Source Builder edition you can select Install Device Using Custom Driver instead. At Test Device tab page you can do following: · See PCI device location and all fields of the PCI header.   · Read or write any header field as well as manipulate with the Command and Status PCI registers.   · Read or write Base Address Registers.   · Listen for the hardware interruptions.   Also you may test your device with the help of built-in RapidDebugger.