Home		Prev Next
Contents RapidDriver Explorer Introduction The User Interface (Overview) Device Description Test Devices Driver Description New RapidDriver Project Step 1: Select Device Step 2: Project Description Step 3: ISA Resources Step 4: Driver Installation Generic RapidDriver Project Port I/O Memory-mapped I/O PCI Devices Working With ISA/PC-104 Devices New ISA/PC-104 Project Hardware Resources for ISA/PC-104 Input/Output (I/O) Port Ranges Memory Address Ranges Interrupt Request (IRQ) Line Direct Memory Access (DMA) Channel Test ISA/PC-104 Device Working With PCI Devices New PCI Driver Project Test PCI Device PCI Header Configuration Space Base Address Registers (BARs) Interruptions Settings for bus-master DMA Working with Parallel Port Devices New Parallel Port Project Test Parallel Port Device Parallel Port Settings LPT Pins Ports And Bits Interrupts Working With USB Devices New USB Project Test USB Device Descriptors and Configuration Vendor/Class Requests Pipe Operations Feature Requests		Feature Requests Go to RapidDriver Main Page This tab is used to send Set Feature, Clear Feature and Get Status requests to USB device."Setup Packet" box reflects contents of setup packet to be send during feature or status request. USB operations not included to other categories can be performed from this tab as well. "Cycle Port" operation simulates a device unplug and replug. "Bandwidth Information" - reports total bandwidth available on the bus and mean bandwidth already in use.